A compact USB 2.0 adapter with case is designed for all 2.5SATA disks up to 9.5 mm height.
It deals with all SATA, SATA II and SATA III 2.5hard disks and SSDs without limiting maximum capacity.
AXAGON SLIMport is a small but very handy helper usable for data migration, disk testing, backup and many other uses.
ANY 7 & 9.5 mm 2.5HDD/SSD ? ANY CAPACITY ? UNIVERSAL USE
Disk installation only takes a few seconds.
Simply plug the disk directly into the SATA connector of the adapter.
The set can be connected to the PC immediately or inserted into a protective case before that.
No screws, just a few simple steps.
THE FASTEST & EASIEST ASSEMBLY ? SCREWLESS
The case holds a standard 2.5disk even with a USB adapter connected.
It also serves to transport or store the adapter itself without the disk, with a cable inside the case.
Minimum dimensions and weight make the product ideally suited also for occasional mobile use.
PRACTICAL CASE ? MINI & LIGHTWEIGHT ? MOBILE
Pure minimalist design of slim and lightweight body.
Pleasantly matte surface finish.
The delicate blue LED indicates power and data transmission.
PURE DESIGN ? SLIM CASE ? MATTE FINISH ? DELICATE BLUE LED
Reading of S.M.A.R.T. information monitoring the condition of the external disk.
Supports spinning down of connected disks as well as the box.
You can boot your computer from an SSD or hard drive in the external box.
HDD S.M.A.R.T. INFO ? AUTO SPIN DOWN ? BOOT SUPPORT
Automatic installation can be handled even by a layman. Drivers are included with operating systems and are installed completely automatically.
The permanently attached USB cable for direct connection to the computer is always at hand and will not be lost.
The power to the box and disk is supplied via USB bus without the need for external power supply.
AUTO INSTALL ? FIXED USB CABLE ? USB POWER
The compact AXAGON ADSA-1S SLIMport3 adapter with USB 2.0 interface for easy connection to a 2.5SATA disk.
A handy tool to quickly connect a laptop disk, including boot support.
Reading of S.M.A.R.T. information monitoring the condition of the connected disks. Supports spindown of connected disks.
The installation can be handled even by a layman - the disk connects to the adapter and the adapter to the computers USB port; the rest is done automatically.
Minimum dimensions and weight, along with an enclosed disc case, make the product ideally suited even for mobile use.
Features:
? Fully compatible with USB 2.0 and backward compatible with USB 1.1.
? Supports transmission rates 12 / 480 Mbit/s (full / high speed).
? Supports 2.5SATA III / II / I disks of all capacities.
? Compliant with Serial ATA 2.0 specification (SATA/300), transmission rates of up to 3 Gb/s (300 MB/s).
? Compliant with Serial ATA 1.0 specification (SATA/150), transmission rates of up to 1.5 Gb/s (150 MB/s).
? The total bandwidth / transmission rate of the adapter is determined by the USB 2.0 interface used (theor. 480 Mbit/s).
? Supports booting from SSD/HDD connected via an USB adapter.
? HDD Auto Spindown support - possibility to set the interval for disk spindown when idle.
? HDD Auto Stop - the disk turns off after your PC spins down.
? Possibility to connect your device while running thanks to the Hot Plug support.
? Full Plug and Play support.
? Connection via direct USB Type A male connector on a 20 cm long cable that is permanently connected to the adapter.
? Power supply via USB bus.
? A blue LED indicating the connection to the computers USB port (permanent light) and data transmission (blinking).
? Compact adapter dimensions 70 x 21 x 11 mm.
? Adapter weight of only 17 g, including a 20 cm USB cable.
? Simple plastic case holds 2.5disk max. 9.5 mm high with USB adapter connected (USB cable is led out through hole in the case).
? For thin 7mm SSDs/HDDs foam pads are included for better fit in the case.
? The case can also serve to transport or store the adapter itself without the disk, with the USB cable inside the case.
? Case dimensions 122 x 78 x 19 mm.
? Case weight 40 g.
Supported OSs: MS Windows XP / Vista / 7 / 8 / 8.1 / 10 and later, Windows Server 2003 / 2008 / 2012 / 2016 and later (supported are all 32- and 64-bit Windows OS versions), Mac OS X 10.x and higher, Linux with kernel 2.6.x and above.
Note: Drivers are included with supported operating systems and are installed completely automatically. No other drivers need to be installed and are not even available.
Package contains:
? USB - SATA adapter with permanently connected 20 cm long cable,
? plastic case for 2.5disk and USB adapter,
? foam pads for 7 mm HDDs and SSDs,
? printed multilingual manual CZ / DE / DK / ENG / ESP / FIN / FR / GR / HR / HU / IT / NL / PL / PT / RO / RU / SK / SWE / TR / BG / CN / ARA,
? packed in a cardboard box.